Loading...
16 results
Search Results
Now showing 1 - 10 of 16
- The effect of polymer/plasticiser ratio in film forming solutions on the properties of chitosan filmsPublication . Fundo, Joana; Galvis-Sanchez, Andrea C.; Delgadillo, Ivonne; Silva, Cristina L. M.; Quintas, Mafalda A. C.In this work physical-chemical properties of chitosan/ glycerol film forming solutions (FFS) and the resulting films were analysed. Solutions were prepared using different concentrations of plasticising agent (glycerol) and chitosan. Films were produced by solvent casting and equilibrated in a controlled atmosphere. FFS water activity and rheological behaviour were determined. Films water content, solubility, water vapour and oxygen permeabilities, thickness, and mechanical and thermal properties were determined. Fourier transform infrared (FTIR) spectroscopy was also used to study the chitosan/glycerol interactions. Results demonstrate that FFS chitosan concentration influenced solutions consistency coefficient and this was related with differences in films water retention and structure. Plasticiser addition led to an increase in films moisture content, solubility and water vapour permeability, water affinity and structural changes. Films thermo-mechanical properties are significantly affected by both chitosan and glycerol addition. FTIR experiments confirm these results.
- The use of fourier-transform near and mid-infrared spectroscopy for sea salt quality characterizationPublication . Galvis-Sánchez, Andrea C.; Lopes, João Almeida; Delgadillo, Ivonne; Rangel, António O. S. S.
- Automatic standard addition method for potentiometric fluoride determination at low levels in food productsPublication . Galvis-Sánchez, Andrea; Santos, João Rodrigo; Rangel, António O.S.S.
- Development of a Turbidimetric Sequential Injection System to Monitor the Codfish Desalting ProcessPublication . Santos, Inês C.; Mesquita, Raquel B. R.; Galvis-Sánchez, Andrea C.; Delgadillo, Ivonne; Rangel, António Osmaro S. S.Salt-cured codfish represents an ancient process of preservation but requires the rehydration of the codfish with the correspondent salt removal. This work describes the development of a sequential injection system for the online turbidimetric determination of chloride during a simulated desalting process. The samples are directly aspirated to the manifold with no need for previous offline treatments; this was possible due to the use on an inline dialysis process; a quantification range from 50.0 mg/L to 20.0 g/L was established using the same manifold configuration. For monitoring the entire process, involving several chloride determinations (ca. 10), less than 3 mL of the desalting water was needed. Furthermore, the overall reagent consumption was quite low: 0.211 mg of AgNO3, 30.6 mg of HNO3, and 31.1 μg of PVA per determination. The accuracy of the system was evaluated by comparison with a potentiometric reference method. The determination rate was 28 and 31 h−1 according to the chloride concentration range. Several simulated desalting processes, under different conditions, were effectively monitored with the developed method.
- Fourier transform near-infrared spectroscopy application for sea salt quality evaluationPublication . Galvis-Sanchez, Andrea C.; Lopes, João Almeida; Delgadillo, Ivonne; Rangel, António O.S.S.Near-infrared (NIR) spectroscopy in diffuse reflectance mode was explored with the objective of discriminating sea salts according to their quality type (traditional salt vs "flower of salt") and geographical origin (Atlantic vs Mediterranean). Sea salts were also analyzed in terms of Ca2+, Mg2+, K+, alkalinity, and sulfate concentrations to support spectroscopic results. High concentrations of Mg2+ and K+ characterized Atlantic samples, while a high Ca2+ content was observed in traditional sea salts. A partial least-squares discriminant analysis model considering the 8500-7500 cm(-1) region permitted the discrimination of salts by quality types. The regions 4650-4350 and 5900-5500 cm(-1) allowed salts classification according to their geographical origin. It was possible to classify correctly 85.3 and 94.8% of the analyzed samples according to the salt type and to the geographical origin, respectively. These results demonstrated that NIR spectroscopy is a suitable and very efficient tool for sea salt quality evaluation.
- A total analytical system featuring a novel solid–liquid extraction chamber for solid sample flow analysisPublication . Galvis-Sánchez, Andrea C.; Santos, João Rodrigo; Rangel, António O. S. S.In this work, a total flow analysis system based on a novel solid–liquid extraction chamber is presented. This strategy enables all the main experimental procedures for the analysis of a solid sample to be performed automatically: enrichment of the liquid extract, sample treatment, filtration of the liquid extract from the solid sample, directing the extract towards detection, and finally cleansing of the chamber for the following solid sample to be analyzed. The chamber designed to be incorporated in the flow manifold presents two main features: it accommodates stirring bars for enhancing the extraction process, and it presents replaceable solid sample containers (a spare part of the solid–liquid extraction chamber) to easily replace the solid sample and therefore enhance sample analysis throughput. The chamber performance was assessed using two different solid samples, an ion exchanger resin and vegetable samples, focussing on proton and nitrate on extraction, respectively. The main figures of merit achieved were relative standard deviation (RSD) and relative error values below 7 % for all determinations. The determination rate for vegetable samples was ca. 12 samples h−1. The proposed strategy may be exploited to perform automatically the analysis of solid samples as it embodies a simple automatic strategy of a very important but time consuming and laborious analytical operation.
- Sea saltPublication . Galvis-Sánchez, Andrea C.; Lopes, João Almeida; Delgadillo, Ivone; Rangel, António O. S. S.The geographical indication (GI) status links a product with the territory and with the biodiversity involved. Besides, the specific knowledge and cultural practices of a human group that permit transforming a resource into a useful good is protected under a GI designation. Traditional sea salt is a hand-harvested product originating exclusively from salt marshes from specific geographical regions. Once salt is harvested, no washing, artificial drying or addition of anti-caking agents are allowed; then, other salts associated with sodium chloride are also maintained. Two quality types of salt can be commercially considered: ‘flower of salt’ and salt, which have distinctive physico-chemical characteristics. The application of analytical methodologies such as atomic spectroscopy, molecular spectroscopy, separation techniques and flow injection systems coupled with chemometric tools can provide significant evidence of sea salt uniqueness, give precise and concise information and promote fair competition in the market, bringing benefits for the producers and consumers.
- Standard addition flow method for potentiometric measurements at low concentration levels: application to the determination of fluoride in food samplesPublication . Galvis-Sánchez, Andrea C.; Santos, João Rodrigo; Rangel, António O. S. S.A standard addition method was implemented by using a flow manifold able to perform automatically multiple standard additions and in-line sample treatment. This analytical strategy was based on the in-line mixing of sample and standard addition solutions, using a merging zone approach. The flow system aimed to exploit the standard addition method to quantify the target analyte particularly in cases where the analyte concentration in the matrix is below the lower limit of linear response of the detector. The feasibility of the proposed flow configuration was assessed through the potentiometric determination of fluoride in sea salts of different origins and different types of coffee in fusions. The limit of quantification of the proposed manifold was 5x 10 6 mol L -1, 10-fold lower than the lower limit of linear response of the potentiometric detector used. A determination rate of 8 samples h -1 was achieved considering an experimental procedure based on three standard additions per sample. The main advantage of the proposed strategy is the simple approach to perform multiple standard additions, which can be implemented with other ion selective electrodes, especially in cases when the primary ion is below the lower limit of linear response of the detector.
- Evaluation of some of the main inorganic ions in brine solutions used for sea salt production by flow injection analysis and fourier-mid infrared spectroscopyPublication . Galvis-Sánchez, Andrea C.; Santos, Inês C.; Mesquita, Raquel B. R.; Lopes, João A.; Delgadillo, Ivonne; Rangel, António O. S. S.
- Monitoring sodium chloride during cod fish desalting process by flow injection spectrometry and infrared spectroscopyPublication . Galvis-Sánchez, Andrea C.; Tóth, Ildikó V.; Portela, Ana; Delgadillo, Ivonne; Rangel, António O. S. S.In order to adapt to the market trends that are moving towards ready-to-use products cod !sh industry is including into their industrial operations as the desalting step. The desalting process is a high cost and time demanding operation. The optimization of the desalting process is of vital importance for the !sh industry in order to assure the homogeneity and predictable concentration of sodium chloride in the !nal hydrated cod !sh product. On the other hand, consumers are more aware about the necessity to bring sodium consumption down to healthy levels to prevent cardiovascular diseases. The application of rapid and simple analytical methodologies that permit the control of the process and ensure food quality is essential in the food industries. This work reports the optimization and application of two analytical methodologies with the objective of monitoring the variation of sodium chloride concentration during cod desalting process. A "ow injection analysis system was developed based on the reaction between chloride and silver nitrate, and the formed precipitate was assessed spectrophotometrically as a turbidity change. A Fourier-mid infrared spectroscopy attenuated total re"ection method was also applied. Different chemical and physical parameters of the "ow injection system were studied and the analytical characteristics of both systems were compared.